Wall Art Installation

Disclaimer - Vinyl lettering can be applied to most textured surfaces, however you may find some difficulty applying lettering to porous or chalk-like surfaces, such as stone, as well as flat or glossy painted surfaces. We are not responsible for any direct, indirect, or consequential damages resulting from the use or inability to use this product.

Wall Art Vinyl Decal consists of 3 layers
* the top layer is the transfer or application tape
* the middle layer is the actual wall art vinyl decal
* the bottom layer is the backing wax paper


Our graphics are so easy to put up, anyone can do it. But beware some of the fancier designs can be tricky if you do not follow the instructions. So read on for a successful project. Please make sure the surface is clean and dry before applying decals. Do not install in temperature below 60 degrees or higher than 95 degrees.

1.Choose the look you want to achieve with your graphics. Cut apart individual parts of the graphic if you wish to rearrange them in a different design.

2.Before removing any backing wax paper, use masking tape to place the wall art vinyl decal on the wall/surface where you want them to be placed.

3.As you take the wall art vinyl decal off to prepare to place them permanently, use the masking tape as placeholders for your graphics placement on the wall/surface.

4.To remove the white backing from the wall art vinyl decal: Lay the graphic face down on a level surface. Peel backing away from graphic, making sure the wall art vinyl decal stays adhered to the application tape. For intricate areas of the graphic: Use a safety pin to hold down the graphic while the backing is removed.

5.Apply graphic with transfer tape onto wall/surface. Smooth entire surface of graphic to wall, using your credit card, working from the middle outward, to smooth out bubbles.

6.To remove transfer tape from wall/graphic: Slowly peel the liner downward off of the wall/graphic. Repeat directions for each decal. And you are done!